gcc installation

[Gonca Orgulu]

 Thank you for the information. I think that i completed configuration, but
 the second step "make bootstrap" gives error messages. I attached the log
 files to this message as a tar file. 
 
 Could you please check them?
 
 Gonca
 
 
 Hi,
 
 Gonca Orgulu wrote:
 > I am new for program installation and am not sys admin.  > I tried to understand the instructions, but i think that i did not > understand very well.
 > Probably, my problem for ld is related to the path definition. I am
 > running the program "configure" as root. While as root, the system
 > does not find ld command. Actually, i have link editor program which is in
 > a different path. I tried to give a path for the ld command in configure  > as below,
 >
 > ld='/usr/ccs/bin/ld'
 >
 > I am not sure i am doing correctly. 
 
 Hm, you don't need to run this as root.
 Here in my env I set the PATH pointing to the ccs/bin/ld. I use the 
 tcsh. This is what I put in my .tcshrc:
 
 setenv PATH /usr/local/bin:/usr/ccs/bin:/usr/bin:$PATH
 setenv CONFIG_SHELL /bin/ksh
 
 Then source this .tcshrc and configure the gcc to your needs.
 
 e.g, in a directory called objdir which is on the same level as the gcc-src.
 
 ../gcc/configure --prefix=<where to install>
 
 after configure completes, a make bootstrap should run through. 

 Andreas
 
 
 
 
 
 
 
-------------- next part --------------
A non-text attachment was scrubbed...
Name: msgs.tar
Type: application/octet-stream
Size: 12800 bytes
Desc: 
URL: <https://gcc.gnu.org/pipermail/gcc/attachments/20030430/5465f36c/attachment.obj>