(R5900) Implementing Vector Support

[Richard Henderson]

On 05/06/2016 09:28 PM, Woon yung Liu wrote:
> Regarding multiplication of vectors, is there a way to work with a multiplication operation that results in something like this (the result is spread across these 3 registers), without re-ordering any elements:
>
> RD: A6xB6, A4xB4, A2xB2, A0xA0
>
> LO: A7xB7, A6xB6, A3xB3, A2xA2
> HI: A5xB5, A4xB4, A1xB1, A0xA0
>
> A0-A7 and B0-B7 are the 8 elements of two V8HI vectors, which are multiplied together to produce a widened multiplication result.
>
> It looks like the vector hi/lo multiplication pattern would work with the values in HI and LO, but the order of the elements don't seem to be in a way that GCC expects.
>
> Assuming that it is possible to put this pattern to use, does GCC allow the vec_widen_smult_hi and
> vec_widen_smult_lo patterns to be combined together? Like for the divmod (division + modulus) patterns.
> The instruction described above (PMULTH) will result in calculation of both the hi and lo parts of the result, in one instruction. Hence combining the two patterns would be more efficient.

You can use this if you reshuffle the results.

Since it appears that PMULTH naturally produces even results in RD, it would 
seem to make the most sense to attempt to construct the odd results from LO+HI. 
  However, I don't see anything in the TX79 isa that's particularly helpful there.

That said,

	pmulth	r0, x, y
	pmflo	t1
	pmfhi	t2
	pcpyld	r1, t1, t2
	pcpyud	r2, t2, t1

would appear to produce the results gcc expects for the hi/lo multiples.

Don't worry overmuch about initially generating two copies of the pmulth 
instruction.  We have a similar problem with the ia64 patterns.  Rely on the 
rtl CSE pass to remove the duplicate instructions.


r~