Building gcc 3.3.2 on HPUX11.11 - make bootstrap (stage3) fails: Bootstrap comparison failure!

[Scelers, Philippe]

Hi
I cannot build gcc 3.2.3 on HP-UX 11.i
Note: I get the same error on HP-UX 11.00.

Configure step:
./configure
--prefix=/free/GNU_BUILD/G1/devenv/distrib/9000/785/B.11.11/gcc-3.2.3
--enable-languages=c,c++,f77 --disable-nls
    Configuring for a hppa2.0w-hp-hpux11.11 host.
    *** This configuration is not supported in the following subdirectories:
         target-libffi target-boehm-gc target-zlib target-libjava zlib
fastjar target-libobjc
        (Any other directories should still work fine.)

Make step:
make bootstrap
  I get an error at stage3: Bootstrap comparison failure!
    make[2]: Leaving directory
`/tmp_mnt/free/GNU_BUILD/G1/devenv/build_src/9000/785/B.11.11/gcc-3.2.3/gcc'
    echo timestamp > stage3_build
    echo stage3_build > stage_last

    Bootstrap complete - make "quickstrap" to redo last build,
    "restage1" through "restage3" to rebuild specific stages,
    or "cleanstrap" to redo the bootstrap from scratch.
    make[1]: Leaving directory
`/tmp_mnt/free/GNU_BUILD/G1/devenv/build_src/9000/785/B.11.11/gcc-3.2.3/gcc'
    Comparing stage2 and stage3 of the compiler
    make[1]: Entering directory
`/tmp_mnt/free/GNU_BUILD/G1/devenv/build_src/9000/785/B.11.11/gcc-3.2.3/gcc'
    rm -f .bad_compare
    ......
    Bootstrap comparison failure!
    alias.o differs
    ..... (lot of object files differs)

Did I missed something? options? prerequisites?


As a workaroud, I try to build binutils-2.14 to configure gcc-3.2.3 with
GNU ld and GNU as
Unfortunately GNU ld is not supported, see message below
Configure step:
./configure
--prefix=/free/GNU_BUILD/G1/tools/distrib/9000/785/B.11.11/binutils-2.14
--disable-nls
    creating cache ./config.cache
    checking host system type... hppa2.0w-hp-hpux11.11
    checking target system type... hppa2.0w-hp-hpux11.11
    checking build system type... hppa2.0w-hp-hpux11.11
    *** This configuration is not supported in the following subdirectories:
         ld
        (Any other directories should still work fine.)
    /usr/ccs/bin/ld: (Warning) At least one PA 2.0 object file
(conftest.o) was detected. The linked output may not run on a PA 1.x system.


I cannot figure out to build gcc-3.2.3 on HP-UX 11.i (and HP-UX 11.00)

Thank you for help,
-- 
Philippe Scelers