[roberts@tsasa.lanl.gov: Problem w/egcs1.1b and XFCom_3DLabs server]

[Doug Roberts]

Egcs folks: Attached is a message that I sent off to XSuse regarding
a problem encountered with their XFCom_3DLabs server. I received
a reply from them indicating that they thought it was a bug in 
the egcs compiler.

Regatds,

Doug

==================================================================
Douglas Roberts, TSA-DO/SA     |
Los Alamos National Laboratory | All good work is done in defiance
dzzr@lanl.gov                  |  of management. -- Bob Woodward
(505)667-4569                  |
==================================================================


------- Start of forwarded message -------

Gentlemen:

There appears to be an incompatibility with kernels 2.0.34 and 2.0.35
and
your XFCom_3DLabs server when the kernels are built with egcs1.1b. The
kernel builds
and boots, but  a seg fault occurs when you try to start the X server.
When the kernels are built with egcs1.03a, everything works as expected.

My system is a Pentium II running Slackware3.5.

Regards,

- --Doug

- --
==================================================================
Douglas Roberts, TSA-DO/SA     |
Los Alamos National Laboratory | All good work is done in defiance
dzzr@lanl.gov                  |  of management. -- Bob Woodward
(505)667-4569                  |
==================================================================
------- End of forwarded message -------