These function attributes are supported on the SH family of processors:
On SH2A targets, this attribute declares a function to be called using the TBR relative addressing mode. The argument to this attribute is the entry number of the same function in a vector table containing all the TBR relative addressable functions. For correct operation the TBR must be setup accordingly to point to the start of the vector table before any functions with this attribute are invoked. Usually a good place to do the initialization is the startup routine. The TBR relative vector table can have at max 256 function entries. The jumps to these functions are generated using a SH2A specific, non delayed branch instruction JSR/N @(disp8,TBR). You must use GAS and GLD from GNU binutils version 2.7 or later for this attribute to work correctly.
In an application, for a function being called once, this attribute saves at least 8 bytes of code; and if other successive calls are being made to the same function, it saves 2 bytes of code per each of these calls.
Use this attribute to indicate that the specified function is an interrupt handler. The compiler generates function entry and exit sequences suitable for use in an interrupt handler when this attribute is present.
Use this attribute on SH targets to indicate that an
function should not save and restore registers R0..R7. This can be used on SH3*
and SH4* targets that have a second R0..R7 register bank for non-reentrant
On SH targets this attribute specifies that the function or struct follows the Renesas ABI.
On the SH2A target, this attribute enables the high-speed register
saving and restoration using a register bank for
routines. Saving to the bank is performed automatically after the CPU
accepts an interrupt that uses a register bank.
The nineteen 32-bit registers comprising general register R0 to R14, control register GBR, and system registers MACH, MACL, and PR and the vector table address offset are saved into a register bank. Register banks are stacked in first-in last-out (FILO) sequence. Restoration from the bank is executed by issuing a RESBANK instruction.
Use this attribute on the SH to indicate an
function should switch to an alternate stack. It expects a string
argument that names a global variable holding the address of the
void *alt_stack; void f () __attribute__ ((interrupt_handler, sp_switch ("alt_stack")));
Use this attribute on the SH for an
interrupt_handler to return using
trapa instead of
rte. This attribute expects an integer
argument specifying the trap number to be used.
On SH targets this function attribute is similar to
but it does not save and restore all registers.