This is the mail archive of the
mailing list for the GCC project.
Re: About loop unrolling and optimize for size
- From: Richard Biener <richard dot guenther at gmail dot com>
- To: "sarah at hederstierna dot com" <fredrik at hederstierna dot com>
- Cc: "gcc at gcc dot gnu dot org" <gcc at gcc dot gnu dot org>
- Date: Fri, 14 Aug 2015 09:28:22 +0200
- Subject: Re: About loop unrolling and optimize for size
- Authentication-results: sourceware.org; auth=none
- References: <263ef4cd6f55417e97d180530b2e64ba at DAG03 dot HMC dot local>
On Thu, Aug 13, 2015 at 6:26 PM, firstname.lastname@example.org
> I'm using an ARM thumb cross compiler for embedded systems and always do optimize for small size with -Os.
> Though I've experimented with optimization flags, and loop unrolling.
> Normally loop unrolling is always bad for size, code is duplicated and size increases.
> Though I discovered that in some special cases where the number of iteration is very small, eg a loop of 2-3 times,
> in this case an unrolling could make code size smaller - eg. losen up registers used for index in loops etc.
> Example when I use the flag "-fpeel-loops" together with -Os I will 99% of the cases get smaller code size for ARM thumb target.
> Some my question is how unrolling works with -Os, is it always totally disabled,
> or are there some cases when it could be tested, eg. with small number iterations, so loop can be eliminated?
> Could eg. "-fpeel-loops" be enabled by default for -Os perhaps? Now its only enabled for -O2 and above I think.
Complete peeling is already enabled with -Os, it is just restricted to
those cases where GCCs cost modeling of the
unrolling operation determines the code size shrinks. If you enable
-fpeel-loops then the cost model allows the
code size to grow - sth not (always) intended with -Os.
The solution is of course to improve the cost modeling and GCCs idea
of followup optimization opportunities.
I do have some incomplete patches to improve that and hope to get back
to it for GCC 6.
If you have (small) testcases that show code size improvements with
-Os -fpeel-loops over -Os and you are
confident they are caused by unrolling please open a bugzilla containing them.
> Thanks and Best Regards