Fw: Strange paths for gcc for x86_64-pc-mingw32

[Tehila Meyzels <TEHILA at il dot ibm dot com>]

 Kai Tietz wrote on 19/02/2007 10:29:13:

> Hi,
>
> May somebody can explain me, the following case. I compiled a
> cross-complier for x86_64-pc-mingw32 and was successful on translare with

> the following build steps:
> 1. configure --target=x86_64-pc-mingw32
> 2. make all-gcc
> 3. make install-gcc
>
> But then I noticed, that the pathes to the tool-chain - which is
installed
> under /usr/local/x86_64-pc-mingw32 - is used while compile, is somehow
> broken for the gcc tool. I assume, that the gcc toolchain is to be found
> under /usr/local/libexec/gcc/x86_64-pc-mingw32/4.3.0, but it is search in

> /usr/local/x86_64-pc-mingw32/libexec/x86_64-pc-mingw32/4.3.0.
> The make command "make install-gcc" installs the toolchain as expected
> under /usr/local/libexec/gcc/x86_64-pc-mingw32/4.3.0.
>
> Can me somebody help ? Is this a bug or normal behaviour ?

You're writing that the toolchain is installed under
/usr/local/x86_64-pc-mingw32,
but you assume it should be under
/usr/local/libexec/gcc/x86_64-pc-mingw32/. Why?
If you want it to be under /usr/local/libexec/gcc/x86_64-pc-mingw32/, you
should configure with --prefix=/usr/local/libexec/gcc.

In case you just need it to find it in the correct place (i.e.,
/usr/local/libexec/gcc/x86_64-pc-mingw32/4.3.0),
you need to put it at the beginning of your $PATH.
(check what you have there with "echo $PATH" and then use setenv/export).

HTH,
Tehila.

>
> Regards,
>  i.A. Kai Tietz
>
> ----------------------------------------
>   Kai Tietz - Software engineering
>   OneVision Software Entwicklungs GmbH & Co KG
>   Dr.-Leo-Ritter-Str. 9, 93049 Regensburg, Germany
>   Phone: +49-941-78004-0
>   FAX:   +49-941-78004-489
>   WWW:   http://www.OneVision.com