This is the mail archive of the mailing list for the GCC project.

Index Nav: [Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav: [Date Prev] [Date Next] [Thread Prev] [Thread Next]

[Fwd: FW: Notification: Inbound Mail Failure]


[ this message has been CCed to in order
to document this incident ]

The mail system of is misconfigured.

I cannot believe I receive this garbage after posting to an
official mailing list.

If Your mail system disallows its users to subscribe
to mailing lists then there are other ways to get things right.

To unsubscribe employees that do not exist anymore
follow the instructions in the mail headers.

I strongly discourage You from delaying any measure
that stops this bullshit immediately.
If after posting to I obtain similar
messages from Your system again, be sure this will have

Markus Werle

Please note that this e-mail address is not the proper address of the person
you are attempting to reach or the person no longer exists with the company.

Please remove this person from your mailing list immediately.

If you feel this to be in error contact the individual directly.

-----Original Message-----
From: Administrator 
Sent: Monday, September 10, 2001 10:39 AM
To: Administrator
Subject: Notification: Inbound Mail Failure 

The following recipients did not receive the attached mail.  A NDR was not
sent to the originator for the following recipients for one of the following

	* The Delivery Status Notification options did not request failure
notification, or requested no notification.

	* The message was of precedence bulk.

NDR reasons are listed with each recipient, along with the notification
requested for that recipient,
or the precedence.

	Precedence: bulk

The message that caused this notification was:

 <<gcc-3.0.1 binaries for hpux-11.0 available now for free>> 


I finally found a place where to put binary distributions of the C/C++/f77
gcc-3.0.1. You can download 2 different 64bit packages and one 32 bit

For further information please refer to

All packages should be unpacked using bzip2 and tar in the root directory
All 3 versions have --prefix=/opt/precompiled/gcc-3.0.1-etc
and should be considered as starting points for own builds.

Please also do not forget to visit

best regards,


Index Nav: [Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav: [Date Prev] [Date Next] [Thread Prev] [Thread Next]