You can take advantage of the auto-vectorizer present in the gcc back end to vectorize loops with GNAT. The corresponding command line switch is -ftree-vectorize but, as it is enabled by default at -O3 and other aggressive optimizations helpful for vectorization also are enabled by default at this level, using -O3 directly is recommended.
You also need to make sure that the target architecture features a supported SIMD instruction set. For example, for the x86 architecture, you should at least specify -msse2 to get significant vectorization (but you don't need to specify it for x86-64 as it is part of the base 64-bit architecture). Similarly, for the PowerPC architecture, you should specify -maltivec.
The preferred loop form for vectorization is the
for iteration scheme.
Loops with a
while iteration scheme can also be vectorized if they are
very simple, but the vectorizer will quickly give up otherwise. With either
iteration scheme, the flow of control must be straight, in particular no
exit statement may appear in the loop body. The loop may however
contain a single nested loop, if it can be vectorized when considered alone:
|A : array (1..4, 1..4) of Long_Float; S : array (1..4) of Long_Float; procedure Sum is begin for I in A'Range(1) loop for J in A'Range(2) loop S (I) := S (I) + A (I, J); end loop; end loop; end Sum;|
The vectorizable operations depend on the targeted SIMD instruction set, but the adding and some of the multiplying operators are generally supported, as well as the logical operators for modular types. Note that, in the former case, enabling overflow checks, for example with -gnato, totally disables vectorization. The other checks are not supposed to have the same definitive effect, although compiling with -gnatp might well reveal cases where some checks do thwart vectorization.
Type conversions may also prevent vectorization if they involve semantics that are not directly supported by the code generator or the SIMD instruction set. A typical example is direct conversion from floating-point to integer types. The solution in this case is to use the following idiom:
Integer (S'Truncation (F))
S is the subtype of floating-point object
In most cases, the vectorizable loops are loops that iterate over arrays. All kinds of array types are supported, i.e. constrained array types with static bounds:
type Array_Type is array (1 .. 4) of Long_Float;
constrained array types with dynamic bounds:
type Array_Type is array (1 .. Q.N) of Long_Float; type Array_Type is array (Q.K .. 4) of Long_Float; type Array_Type is array (Q.K .. Q.N) of Long_Float;
or unconstrained array types:
type Array_Type is array (Positive range <>) of Long_Float;
The quality of the generated code decreases when the dynamic aspect of the array type increases, the worst code being generated for unconstrained array types. This is so because, the less information the compiler has about the bounds of the array, the more fallback code it needs to generate in order to fix things up at run time.
You can obtain information about the vectorization performed by the compiler by specifying -ftree-vectorizer-verbose=N. For more details of this switch, see Options for Debugging Your Program or GCC.