4.2.4 Output Control
The following switches allow additional control over the output
generated by the binder.
- Generate binder program in Ada (default). The binder program is named
b~mainprog.adb by default. This can be changed with
- Check only. Do not generate the binder output file. In this mode the
binder performs all error checks but does not generate an output file.
- Generate binder program in C. The binder program is named
This can be changed with -o
- Output complete list of elaboration-order dependencies, showing the
reason for each dependency. This output can be rather extensive but may
be useful in diagnosing problems with elaboration order. The output is
written to stdout.
- Output usage information. The output is written to stdout.
- Output linker options to stdout. Includes library search paths,
contents of pragmas Ident and Linker_Options, and libraries added
- Output chosen elaboration order. The output is written to stdout.
- Output full names of all the object files that must be linked to provide
the Ada component of the program. The output is written to stdout.
This list includes the files explicitly supplied and referenced by the user
as well as implicitly referenced run-time unit files. The latter are
omitted if the corresponding units reside in shared libraries. The
directory names for the run-time units depend on the system configuration.
- -o file
- Set name of output file to file instead of the normal
b~mainprog.adb default. Note that file denote the Ada
binder generated body filename. In C mode you would normally give
file an extension of .c because it will be a C source program.
Note that if this option is used, then linking must be done manually.
It is not possible to use gnatlink in this case, since it cannot locate
the binder file.
- Generate list of
pragma Restrictions that could be applied to
the current unit. This is useful for code audit purposes, and also may
be used to improve code generation in some cases.