Re: [Ping] Port of VTV for Cygwin and MinGW

["H.J. Lu" <hjl dot tools at gmail dot com>]

On Wed, Jan 28, 2015 at 2:58 PM, Caroline Tice <cmtice@google.com> wrote:
> Since all the pieces of this patch have been approved, I will commit
> it later today (since Patrick does not have commit privileges).

I got

configure: error: conditional "VTV_CYGMIN" was never defined.
Usually this means the macro was only invoked conditionally.
Makefile:12580: recipe for target 'configure-stage1-target-libstdc++-v3' failed
make[5]: *** [configure-stage1-target-libstdc++-v3] Error 1

>
> -- Caroline Tice
> cmtice@google.com
>
>
>
> On Wed, Jan 28, 2015 at 3:31 AM, Patrick Wollgast
> <patrick.wollgast@rub.de> wrote:
>> Ping.
>>
>> https://gcc.gnu.org/ml/gcc-patches/2015-01/msg01270.html
>>
>> On 15.01.2015 22:50, Patrick Wollgast wrote:
>>> On 15.01.2015 17:01, Ian Lance Taylor wrote:
>>>> On Wed, Jan 14, 2015 at 11:54 PM, Patrick Wollgast
>>>> <patrick.wollgast@rub.de> wrote:
>>>>> Is there something I'm still supposed to do, since I don't have write
>>>>> access and this was the last part missing an "OK"?
>>>>
>>>> Somebody with write access will need to commit the patch for you.  You
>>>> should send a new clean patch including all the changes, along with
>>>> updated ChangeLog entries.
>>>>
>>>> Ian
>>>>
>>>
>>> For the clean patch I co'ed the latest version of the trunk again and
>>> applied my patch. It applies correctly, except for two changes:
>>>
>>> patching file libgcc/Makefile.in
>>> Hunk #1 succeeded at 995 with fuzz 2 (offset 9 lines).
>>> Hunk #2 succeeded at 1020 (offset 17 lines).
>>>
>>>> # This is a version of crtbegin for -static links.
>>>> crtbeginT$(objext): $(srcdir)/crtstuff.c
>>>>      $(crt_compile) $(CRTSTUFF_T_CFLAGS) -c $< -DCRT_BEGIN
>>>> -DCRTSTUFFT_O
>>>> endif
>>>>
>>>> ifeq ($(enable_vtable_verify),yes)
>>>> # These are used in vtable verification; see comments in source files
>>>> for
>>>> # more details.
>>>
>>> I had to move the endif down, since something was added before
>>> "ifeq ($(enable_vtable_verify),yes)" inside the if.
>>>
>>>> # This is a version of crtbegin for -static links.
>>>> crtbeginT$(objext): $(srcdir)/crtstuff.c
>>>>      $(crt_compile) $(CRTSTUFF_T_CFLAGS) -c $< -DCRT_BEGIN
>>>> -DCRTSTUFFT_O
>>>>
>>>> # crtoffloadbegin and crtoffloadend contain symbols, that mark the
>>>> begin and
>>>> # the end of tables with addresses, required for offloading.
>>>> crtoffloadbegin$(objext): $(srcdir)/offloadstuff.c
>>>>      $(crt_compile) $(CRTSTUFF_T_CFLAGS) -c $< -DCRT_BEGIN
>>>>
>>>> crtoffloadend$(objext): $(srcdir)/offloadstuff.c
>>>>      $(crt_compile) $(CRTSTUFF_T_CFLAGS) -c $< -DCRT_END
>>>> endif
>>>>
>>>> ifeq ($(enable_vtable_verify),yes)
>>>> # These are used in vtable verification; see comments in source files
>>>> for
>>>> # more details.
>>>
>>>
>>> patching file libgcc/config.host
>>> Hunk #1 succeeded at 621 (offset 6 lines).
>>> Hunk #2 succeeded at 640 (offset 6 lines).
>>> Hunk #3 succeeded at 660 (offset 6 lines).
>>> Hunk #4 succeeded at 1198 with fuzz 2 (offset 495 lines).
>>>
>>>>      tmake_file="${tmake_file} ${tmake_eh_file} ${tmake_dlldir_file}
>>> i386/t-slibgcc-cygming i386/t-mingw32 t-dfprules i386/t-crtfm i386/t-chkstk"
>>>>      extra_parts="$extra_parts crtfastmath.o"
>>>
>>> The last two lines were changed to the following two lines.
>>>
>>>>      tmake_file="${tmake_file} ${tmake_eh_file} ${tmake_dlldir_file}
>>> i386/t-slibgcc-cygming i386/t-cygming i386/t-mingw32 t-dfprules
>>> i386/t-crtfm i386/t-chkstk"
>>>>      extra_parts="$extra_parts crtbegin.o crtend.o crtfastmath.o"
>>>
>>> And therefore Hunk #4, which follows these lines, wasn't applied correctly.
>>>
>>> These two parts were corrected in vtv_cygmin_clean.patch. For
>>> convenience I also added vtv_cygmin_unclean.patch, which is the patch
>>> from my last mail.
>>>
>>> Regards,
>>> Patrick
>>>



-- 
H.J.