Reloading is going wrong?

[Mohamed Shafi <shafitvm at gmail dot com>]

Hello all,

I am doing a port for a 32bit target in GCC 4.4.0. Of the addressing
modes that are allowed by my target the one with (base register +
offset) is restrictive in QImode. The restriction is that if the base
register is not Stack Pointer then this kind of address cannot come in
a load instruction but only in store instruction.

 To implement this i added constrains for all supported memory
operations in QImode. So the pattern is as follows

(define_insn "movqi"
  [(set (match_operand:QI 0 "nonimmediate_operand"
             "=b,b,d,t,d, b,Ss0, Ss1, a,Se1, Sb2,  b,Sd3,  d,Se0")
        (match_operand:QI 1 "general_operand"
              "I,  L,d,d,t, Ss0,b,  b,    Se1,a,  b,     Sd3,b,  Se0,d"))]

where
d is data registers
a is address registers
b is data and address registers
Sb2 is Rn + offset addressing mode
Sd3 is SP + offset addressing mode

Se0 - (Rn), (Rn)+, (Rn)-, (Rn + Ri) and Post modify register addressing mode
Se1 - Se0 excluding Post modify register addressing mode

I believe that there are enough combinations available for the reload
to try for alternate addressing mode if it encounters the restrictive
addressing mode. But I am still getting the following error

main1.c:11: error: insn does not satisfy its constraints:
(insn 30 29 7 2 main1.c:9 (set (reg:QI 2 d2 [orig:61 <variable>.a+1 ] [61])
        (mem/s/j:QI (plus:SI (reg:SI 16 r0)
                (const_int 1 [0x1])) [0 <variable>.a+1 S1 A8])) 41
{movqi} (nil))
main1.c:11: internal compiler error: in reload_cse_simplify_operands,
at postreload.c:396


So what am i doing wrong?
Cant this scenario be solved by the reload pass?
How can generate instructions with the QImode restriction?

Regards,
Shafi